Notices


Reply
Thread Tools
Posts: 297 | Thanked: 192 times | Joined on Dec 2009 @ Norway
#1
Hey guys,
I haven't posted here in a long while, but I still have a functioning Nokia N900 at hand. The problem is that it is becoming increasingly difficult to maintain batteries for it. The first battery started to expand, and so I had to toss it and get a new one (not Nokia-branded), only to find that it lied about its capacity.

This made me want to approach using a DC power supply to drive the device in place of the battery. I'll skip the reasoning and etc. and get to the case:

- If you connect a stable DC power supply set at 3.7V, uncapped amperage, the device *does not* turn on.

I started to research the so-called BSI-pin on the battery, which is (to my understanding) a circuit between GND and BSI with a 100kOhm resistance, meant to identify the battery characteristics.
I found the following table of resistances online:
http://pinoutguide.com/CellularPhone...y_pinout.shtml

I interpreted this in two ways:
- Does it need a 100kOhm resistor between BSI and GND?
- Is the internal resistance on the device terminals (BSI and GND) supposed to be 100kOhm?

I tried both of these, using a 100kOhm for the first interpretation, and a 430kOhm resistor to achieve 100kOhm resistance on the battery terminals (of course, capacitance made this a pain to measure). In both cases, the device responds in the following way:
- I hold down the power button
- The LED "charges up" in a blue color
- The screen turns on, black, as if NOLO was loading
- The device proceeds to turn off as soon as I release the power button
The power supply displayed an amperage of 250mA for a certain period of time while "booting", but flats out to 100mA afterwards.
After doing this, the device would still turn on when I inserted a battery.

I tested the same setup on another Nokia device (a Nokia 5700) only to get the same response (screen turns on, turns off after letting go of power button), including the same amperage readings. (And of course I adjusted the resistor for the battery type).

Most of my understanding of the battery circuit is based on the BSI reporting *battery model*. A single article online said that BSI was implemented with a termistor, not a resistor, but it also referred to NiMH batteries.

I didn't try ramping up the voltage. I know that some Li-Ion batteries have different voltages at different charges, but I didn't want to get risky.

Has anyone had success with this?
 

The Following 7 Users Say Thank You to Nokia 5700 For This Useful Post:
Reply

Thread Tools

 
Forum Jump


All times are GMT. The time now is 17:58.