Thread
:
Booting from MMC on N800 Now Available!!
View Single Post
torx
2007-05-31 , 04:37
Posts: 231 | Thanked: 21 times | Joined on May 2007 @ Singapore
#
180
Alright, i need some pointers here.
I followed the procedures and had everything set up properly. However, when i boot up using the MMC partion, it works fine for about 30s and reboots.
So this morning, i reflashed the firmware, installed dbserver and xterm, and followed the procedures again. Same thing, works fine for 30s and reboots.
Doubt this will make any difference, but i used the tar program that came along with the latest firmware. It was there by default, never had to install it despite what the instructions said.
Last edited by torx; 2007-05-31 at
04:41
.
Quote & Reply
|
torx
View Public Profile
Send a private message to torx
Find all posts by torx