Thread
:
[ announce ] hackattack!
View Single Post
justmemory
2012-05-30 , 12:35
Posts: 391 | Thanked: 908 times | Joined on Aug 2011 @ suncity
#
153
hi, everyone!
i'm facing a problem with wepon, so i would like to ask for some help:
i upgraded the power kernel from v49 to v50 yesterday, and when i tested whether everything is working fine, i tried wepon and saw the following error message:
"BusyBox v1.10.2 (Debian 3:1.10.2.legal-1osso30+0m5) built-in shell (ash)
Enter 'help' for a list of built-in commands.
~ $ sudo gainroot
Root shell enabled
BusyBox v1.10.2 (Debian 3:1.10.2.legal-1osso30+0m5) built-in shell (ash)
Enter 'help' for a list of built-in commands.
/home/user # wepon
insmod: error inserting '/opt/wifi_mon/compat.ko': -1 Unknown symbol in module
insmod: error inserting '/opt/wifi_mon/cfg80211.ko': -1 Unknown symbol in module
insmod: error inserting '/opt/wifi_mon/mac80211.ko': -1 Unknown symbol in module
insmod: error inserting '/opt/wifi_mon/wl1251.ko': -1 Unknown symbol in module
insmod: error inserting '/opt/wifi_mon/wl1251_spi.ko': -1 Unknown symbol in module
ifconfig: SIOCGIFFLAGS: No such device
nl80211 not found.
ifconfig: SIOCGIFFLAGS: No such device
ifconfig: SIOCGIFFLAGS: No such device
Error for wireless request "Set Mode" (8B06) :
SET failed on device wlan0 ; No such device.
ifconfig: SIOCGIFFLAGS: No such device
[!] unable to import pexpect
[!] if your chipset is intel4965; the fake-auth workaround will fail
[!] unable to import tkinter -- GUI disabled
.;' `;,
.;' ,;' `;, `;, WiFite r78
.;' ,;' ,;' `;, `;, `;,
:: :: : ( ) : :: :: mass WEP/WPA cracker
':. ':. ':. /_\ ,:' ,:' ,:'
':. ':. /___\ ,:' ,:' designed for backtrack4
':. /_____\ ,:'
/ \
[+] WARNING: recommended packages/apps were not found pyrit, cowpatty
[+] targeting networks with signal power greater than 12dB
[+] set WEP replay pps: 500/sec
[+] anonymous mac address enabled
[+] searching for devices in monitor mode...
[!] no wireless interfaces are in monitor mode!
[!] no devices are capable of monitor mode!
[!] perhaps you need to install new drivers
[+] this program will now exit."
the wifi was on, so i think there were wireless interfaces...
so i tried the followings: i downloaded the wepon, wepoff and the wifi.tgz again, and put them into the right folders, and typed the
chmod +x
commands. but it did not help, the error message is the same. is it possible that wepon is not compatible with power kernel v50...? (with v49 it run smoothly)
thanks,
jm
Quote & Reply
|
justmemory
View Public Profile
Send a private message to justmemory
Find all posts by justmemory