View Single Post
Posts: 2,802 | Thanked: 4,491 times | Joined on Nov 2007
#13
Crap, after various unsuccesful attempts to build & boot a modern kernel it seems I managed to fry my N810's camera:

Code:
[    1.101562] OMAP GPIO switch handler initializing
[    1.101562] gpio-switch: required switch not found (-1, cam_act)
[    1.101562] gpio-switch: required switch not found (-1, cam_turn)
[    1.101562] slide (GPIO 110) is now open
[    1.101562] kb_lock (GPIO 102) is now open
[    1.101562] headphone (GPIO 107) is now disconnected
[    1.101562] menelaus 1-0072: Setting voltage 'VMEM' to 1500 mV (reg 0x0a, val 0xb4)
[    1.117187] menelaus 1-0072: Setting voltage 'VIO' to 2500 mV (reg 0x0a, val 0xb8)
[    1.164062] tcm825x_read_reg: trying again (-121)
[    1.179687] tcm825x_read_reg: trying again (-121)
[    1.195312] tcm825x_read_reg: trying again (-121)
[    1.210937] tcm825x_read_reg: trying again (-121)
[    1.226562] tcm825x_read_reg: trying again (-121)
[    1.242187] tcm825x_read_reg: trying again (-121)
[    1.257812] tcm825x_read_reg: trying again (-121)
[    1.273437] tcm825x_read_reg: trying again (-121)
[    1.273437] mmci-omap mmci-omap.1: command timeout (CMD8)
[    1.273437] mmci-omap mmci-omap.1: command timeout (CMD8)
[    1.289062] mmci-omap mmci-omap.1: command timeout (CMD8)
[    1.289062] mmci-omap mmci-omap.1: command timeout (CMD8)
[    1.289062] dev_init(): Failed to detect TCM825x sensor chip
[    1.289062] omap24xxcam omap24xxcam: cannot initialize sensor, error -16
(No, flashing vanilla Diablo, leaving the battery out for a while etc didn't help)

No one's to blame but me of course, but be careful out there!
 

The Following 2 Users Say Thank You to lma For This Useful Post: