Updated the status-area-applet for battery yesterday, but it still showing the battery not calibrated text. I'm currently using devel and thumb repos. I swap batteries every morning because my usb is broken, but I remember that I had the estimated time left readings working for a while. Is there any console commands I could use to find out where the problem lies. Output from bq27200.sh script follows./home/user # bq27200.sh
LOOPMODE=0 RS=22
Reading values...........................done.

CSOC: 0 % RSOC: 0 %
Average Current: 360 mA
TTF: 65535 minutes TTE: 0 minutes
NAC: 0 mAh CACD: 0 mAh CACT: 0 mAh
SI: 13 mA STTE: 0 minutes
MLI: 934 mA MLTTE: 0 minutes
AR: 0 mA ARTTE: 65535 minutes
Last Measured Discharge: 1860 mAh
Cycle Count since Learning: 11 Total Cycle Count since last full reset: 11
Reported Battery Voltage: 3947 mV
Battery Gauge die Temperature: 33 C
Flags: 0x10
Charge:0 NOACT:0 IMIN:0 CI:1 CALIP:0 VDQ:0 EDV1:0 EDVF: 0
eeprom data:
ILMD=1869 EDVF=3000 EDV1=3248 ISLC=18
DMF=14700 nanoVolt SD=201 thousandths of percent per day
AGELMD=1 TAPER=93 mA
IMLC=934 mA
/home/user # bq27200.sh
LOOPMODE=0 RS=22
Reading values...........................done.