Thread
:
Mobile hotspot make my mobile into brick
View Single Post
binu_ji
2010-11-18 , 03:25
Posts: 30 | Thanked: 16 times | Joined on Nov 2010 @ Nagercoil, India
#
5
Thanks friends for your replies especially @thecubed for pointing out the USB pads on the board for easy soldering the data lines to the port.
May i know the use for ID pin in the connector. Is it needed for flashing the mobile? Since its hard to solder this pin to the component on the board.
Quote & Reply
|
binu_ji
View Public Profile
Send a private message to binu_ji
Find all posts by binu_ji