Re: Jolla OtherHalf eInk/ePaper display
Quote:
|
Re: Jolla OtherHalf eInk/ePaper display
Quote:
|
Re: Jolla OtherHalf eInk/ePaper display
Quote:
|
Re: Jolla OtherHalf eInk/ePaper display
Great work, kimmoli - hats off to you.
Quote:
Quote:
|
Re: Jolla OtherHalf eInk/ePaper display
1 Attachment(s)
I got some more auspicious communication from one display manufacturer, but it might take a while.
Unitl then, work on 2.7" version will slowly continue. meanwhile, the badger is ATMEGA328 based, which has low amount of memory, and therefore the display buffer is located on the SD card. I haven't yet figured out is it possible to have the bufffer internally if use micro with larger RAM. But it also can show images (or ebooks) stored in the SD card, so it could be that this SD card is available externally (?) (but the display will only work when SD card is inserted) Early 3d sketch: |
Re: Jolla OtherHalf eInk/ePaper display
Quote:
This needs +15V, -15V, +22V and -20V voltages and waveforms generated externally. (Recommended to use external ASIC) Reminds me of one year-ago epaper project with kindle display, which i fustrated to while not getting timings right.. https://lh3.googleusercontent.com/-6...140129_002.jpg |
Re: Jolla OtherHalf eInk/ePaper display
Quote:
|
Re: Jolla OtherHalf eInk/ePaper display
Quote:
And the get-it-working-properly odds are smaller. |
Re: Jolla OtherHalf eInk/ePaper display
You made my tears dry out Kimmoli.
|
Re: Jolla OtherHalf eInk/ePaper display
1 Attachment(s)
back to this project while waiting prints...
Got one loose 2.7" display today and breakout board. Then need to pick a microcontroller to do the job. atmega328 or any other used on arduino would be easy as has most of the sw ready. but i have something personal against atmel. maybe i will make testing with teensy 3.1 which i should have few somewhere. http://www.pjrc.com/store/teensy31.jpg This is familiar to me, supports most of the arduino libraries. Programming firmware to the K20 used on teensy custom designs requires auxiliary cpu, but it can be hooked on programming adapter (this is the small MINI54 on the lower left corner) Have to check memory requirements of used libs, but this has 256kB flash and 64kB ram (compared to atmega328 32kB flash and 2kB ram) so maybe no sd card needed... below is first block-diagram. |
All times are GMT. The time now is 07:53. |
vBulletin® Version 3.8.8